Abstract
Carbon nanotube wires are promising candidates for next-generation beam instrumentation because of their ultralow mass, radiation tolerance, and potential for stable mechanical and structural behaviour under extreme operating conditions. However, their performance is strongly influenced by catalyst contamination, graphitic disorder, and residual microstrain inherited from fabrication and bundle architecture. Understanding how these factors vary across different CNT wire architectures is essential for developing reliable low-density conductors for future accelerator systems. This study presents a comparative structural and mechanical investigation of carbon nanotube wires spanning distinct nanotube types, fabrication routes, and diameters from 10μm to 50μm, examined before and after nitric-acid purification and twist fixation. Raman spectroscopy, scanning electron microscopy, energy-dispersive X-ray analysis, tensile testing, and in situ synchrotron X-ray diffraction were combined to quantify graphitic order, lattice spacing, and spatial heterogeneity. Strong architecture-dependent behaviour was observed. The 10μm wire exhibited compressed basal-plane spacing and large spatial variability, whereas the 50μm multi-walled-dominant wire remained close to relaxed turbostratic spacing. Purification reduced impurity content, improved graphitic coherence, and enhanced tensile stiffness, including an increase from 30.8 GPa to 68.4 GPa in the 10μm wire, while preserving the underlying hierarchy of residual strain across suppliers. The results demonstrate that purification improves structural uniformity and mechanical consistency, but that the dominant lattice strain state is primarily governed by nanotube architecture and bundle topology rather than chemical treatment.
| Original language | English |
|---|---|
| Article number | 122109 |
| Number of pages | 15 |
| Journal | Carbon |
| Volume | 261 |
| Issue number | Part B |
| Early online date | 18 Sept 2026 |
| DOIs | |
| Publication status | E-pub ahead of print - 18 Sept 2026 |
Acknowledgements
The authors gratefully acknowledge support from the beamline staff at Diamond Light Source during the synchrotron X-ray diffraction experiments. In particular, the assistance of Igor Dolbnya was essential for the successful execution of the measurements. The authors also thank Andrew Malandain and the Diamond technicians for their support in the setup and alignment of the experimental apparatus. Valuable support from Philip Fletcher, and Robinson Novemen (University of Bath) is also sincerely acknowledged. The authors further thankProfessor Chris Bowen for his review and corrections. Carbon nanotube wire samples were supplied by Hisashi Sugime and Yoku Inoue of Kindai University, as well as by Dexmat Inc. and Hitachi Zosen Corporation, with additional samples facilitated by Mariusz Sapinski of the Paul Scherrer Institute.
Funding
This research did not receive funding through a specific research grant. The work was institutionally supported by the European Organization for Nuclear Research (CERN). Diamond Light Source provided beamtime access and associated travel support under proposal OM37812.
Keywords
- Bundle packing
- Carbon nanotube wires
- Chemical purification
- Mechanical properties
- Microstrain
- Raman spectroscopy
- Synchrotron X-ray diffraction
ASJC Scopus subject areas
- General Chemistry
- General Materials Science
Fingerprint
Dive into the research topics of 'In situ synchrotron X-ray diffraction of carbon nanotube wires under tension: Microstrain and graphitic order'. Together they form a unique fingerprint.Cite this
- APA
- Standard
- Harvard
- Vancouver
- Author
- BIBTEX
- RIS