Research Output 2008 2019

Filter
Paper
2016
2 Citations (Scopus)

Parallel kinematic mechanisms for distributed actuation of future structures

Lai, G., Plummer, A., Cleaver, D. & Zhou, H., 3 Jul 2016. 12 p.

Research output: Contribution to conferencePaper

Open Access
File
Kinematics
Actuators
Pneumatics
Muscle
Bearings (structural)
2015

Comparison of the minimum gap in a fluid lubricated bearing for compressible and incompressible flow

Bailey, N., Hibberd, S. & Power, H., 2015.

Research output: Contribution to conferencePaper

1 Citation (Scopus)

Modelling and simulation of ingress into the rim seal and wheelspace of a gas-turbine rotor-stator configuration

Liu, J., Weaver, A., Shih, T. I. P., Sangan, C. & Lock, G., 2015, p. AIAA-2015-1445.

Research output: Contribution to conferencePaper

Probability of bearing failure for a high speed thrust bearing including random input parameters

Bailey, N., Hibberd, S. & Power, H., 2015.

Research output: Contribution to conferencePaper

2014

Analysis of dynamical performance and contact for a high speed thrust bearing including slip effects

Bailey, N., Hibberd, S. & Power, H., 2014.

Research output: Contribution to conferencePaper

2013

Dynamics of fluid film bearings

Bailey, N., Cliffe, A., Hibberd, S. & Power, H., 2013.

Research output: Contribution to conferencePaper

2012
3 Citations (Scopus)

Computational extrapolation of turbine sealing effectiveness from test rig to engine conditions

Teuber, R., Li, Y. S., Maltson, J., Wilson, M., Lock, G. & Owen, J. M., 2012, p. 1971-1982. 12 p.

Research output: Contribution to conferencePaper

Extrapolation
Seals
Turbines
Engines
Flow rate
5 Citations (Scopus)

Model simplifications for numerical simulation of ingestion through gas turbine rim seals

Rabs, M., Benra, F-K., Dohmen, H. J., Lock, G. D. & Schneider, O., 2012.

Research output: Contribution to conferencePaper

Seals
Gas turbines
Engines
Computer simulation
Ingestion (engines)
2009

Effect of Location of Nozzles on Heat Transfer in pre-Swirl Cooling Systems

Kakade, V., Lock, G., Wilson, M., Owen, J. M. & Mayhew, J. E., Jun 2009.

Research output: Contribution to conferencePaper

2008
4 Citations (Scopus)

Aero-Thermal Investigation of Tip Leakage Flow in a Film-Cooled Industrial Turbine

Krishnababu, S. K., Booth, G. D., Hodson, H. P., Lock, G. & Dawes, W. N., May 2008.

Research output: Contribution to conferencePaper

4 Citations (Scopus)

Aero-thermal investigation of tip leakage flow in a film cooled industrial turbine rotor

Krishnababu, S. K., Hodson, H. P., Dawes, W. N., Lock, G., Booth, G. D. & SIEMENS Industrial Turbomachinery Ltd, Lincoln, United Kingdom, Jun 2008, p. 177-186. 10 p.

Research output: Contribution to conferencePaper

Turbines
Rotors
Coolants
Heat transfer
Heat flux

An Experimental and Computational of Low Re Number Transitional Flows over an Aerofoil with Leading Edge Slat

Genc, M. S., Lock, G. & Kaynak, U., 14 Sep 2008.

Research output: Contribution to conferencePaper

6 Citations (Scopus)

An experimental and computational study of low Re number transitional flows over an aerofoil with leading edge slat

Genc, M. S., Lock, G. & Kaynak, U., 2008.

Research output: Contribution to conferencePaper

Airfoils
Angle of attack
Fluid dynamics
Flow control
Momentum
3 Citations (Scopus)

Effect of Radial Location of Nozzles on Performance of Pre-Swirl Systems

Lewis, P., Wilson, M., Lock, G. & Owen, J. M., 2008, p. 1397-1406. 10 p.

Research output: Contribution to conferencePaper

Nozzles
Stators
Wheels
Reynolds number
Rotors
1 Citation (Scopus)

Experimental Characterisation of Heat Transfer in Exhaust Pipe Sections

Bannister, C., Brace, C., Lock, G., Taylor, J., Brooks, T. & Fraser, N., 2008.

Research output: Contribution to conferencePaper

Pipe
Heat transfer
Nusselt number
Gasoline
Reynolds number

Thermal imaging establishes behavioural fever in the desert locust, Schistocerca gregaria during mycosis

Hunt, V., Charney, K. & Lock, G., Jul 2008.

Research output: Contribution to conferencePaper